MW Solutions

Express Yourself Tagholder

License Plate Holder and License Plate Frame Mounting Instructions

License Plate Holder and License Plate Frame Mounting Instructions

EYTTM Installation Instructions for the 2-Piece; 1) License Plate Holder and 2) License Plate Frame

(For either Front or Rear Mount)

See Note below prior to mounting

The EYTTM License Plate Holder has four (4) License Plate Mounting holes (A), and five (5) Frame Mounting holes (C).

Located on the rear of the EYTTM Frame is a T-Lock Fitting (C) and four (4) Alignment Posts (D)


Express Yourself Tagholder License Plate frame image

                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                       

To Mount the EYTTM License Plate Holder

1. Remove the existing license plate and/or plate frame.

(Volvo Owners - Remove the four (4) Cap Nuts and then install the four (4)T-Nuts from the Volvo Mounting Kit a few turns on the Volvo's threaded studs and then proceed to Step 2.).

2. Align the four (4) EYTTM License Plate Holder mounting holes to the existing vehicle license plate mounting holes.

3. Position the five (5) License Plate Frame mounting holes at the bottom for Bottom Mount Frames or the (5) Frame mounting holes at the top for Top Mount Frames.

4. Secure the state license plate and the EYTLicense Plate Holder to the vehicle with mounting screws.

To Mount the EYTTM License Plate Frame

1. Remove EYT™ License Plate Frame from the packaging.

2. Align the T-Lock with the License Plate Holder center hole.

3. Press the Frame center into the Plate Holder until the T-Lock engages.

4. Press the four (4) Alignment Post’s into the License Plate Holder until the Frame is snug to the License Plate Holder.

The EYTTM License Plate Frame is securely affixed to the EYTTM License Plate Holder.

EYT™ Frame Removal process:

1. Gently pry the Frame 'ends' from the Plate Holder. 

2. 'Pinch' the T-Lock fitting to release the Frame from the Plate Holder.

(To install a different Frame, follow steps 2-4 above).

Note - Due to variation in license plate mounting hardware, the Express Yourself Tagholder (EYTLicense Plate Frame and License Plate Holder set may not include your exact mounting hardware. Prior to installing your EYTTM  License Plate Holder, we suggest you remove one license plate mounting screw and purchase replacement mounting screws from a local hardware retailer. The replacement screws should be three-quarters (¾) of an inch longer than your current license plate mounting screws.

Volvo owners 

Your mounting system is unique however we have a solution. A 6 MM Mounting Screw Kit allows you to easily attach your EYTTM License Plate Holder to your Volvo license plate bracket. Reserve your Kit here

License Plate Frames and License Plate Holders

Made in the USA since 2012

Easily Mount Express Yourself Tagholder License Plate FramesMW Solutions LLC
14 Autumn Street
Windham, New Hampshire 03087
Click HERE to Call: 800-253-2041

Complete Site Directory