
Plate Holder, Mounting Screws, & Mounting Instructions for Express Yourself Tagholder Frames
Plate Holder, Mounting Screws, & Mounting Instructions for Express Yourself Tagholder (EYTTM) Frames
Note - Shown is a Top Mount Frame (sold separately) mounted on a Plate Holder.
EYTTM License Plate Holder Advantages;
- Avoid the legal difficulties associated with license plate frames
- Accommodates either a Bottom Mount or a Top Mount Frame.
- Mount the Frame without removing the state license plate.
- Legal in all 50 States and appeals to ALL vehicle owners.
- Durable, Rustproof, Weatherproof, & Car Wash Safe.
- Includes four (4) #12 x 1-1/2-inch mounting screws.
- Provides 100% state license plate visibility
- Front or Rear Mount on most vehicles.
- Produced in the USA.
Note - The white 'dots' on the Plate Holder image (shown above) are the four (4) license plate mounting holes and the five (5) Frame mounting holes along the bottom edge where the Frame is attached. The Plate Holder is rotated to accommodate a Top Mount Frame.
Component |
Height |
Width |
Plate Holder |
7.00" (177.80 MM) |
12.50" (317.50 MM) |
Frame |
1.25" (31.75 MM) |
12.50" (317.50 MM) |
Plate Holder with mounted Frame |
7.50" (190.50 MM) |
*Note - Due to variation in license plate mounting hardware, the EYTTM Mounting Screws may not be suitable for your mounting application.
Prior to installing your EYT™ Plate Holder, we suggest you remove one license plate mounting screw and purchase replacement mounting screws from your local hardware retailer. The replacement screws should be three quarters (3/4') of an inch (19.05MM) longer than your current license plate mounting screws.
Note to Volvo owners
Your mounting system is unique however we have the solution. A 6 MM Mounting Screw Kit lets you easily attach the Plate Holder to your Volvo license plate bracket. You can reserve a Kit here
License Plate Frames and License Plate Holders
Made in the USA since 2012
